COTTON CANDY MACHINE ACB-09-120 rev 11-May-18
handle in order to loosen the parts.
The sidewall is made of high-grade stainless steel. Nevertheless, the part
might be damaged by excessive tightening the screws, by throwing, or by
heavy impact.
4. Remove central wing nut (21), steel washer (20), plastic holding washer
(19). Then, using a 7mm nut driver or wrench, remove the nuts that are
securing the wire ends to the terminal posts. Remove the nuts, lock
washers, terminal ends and washers and you can then lift off the sidewall
with heating element (9) as one unit.
5. Wash the sidewall and heating element with very hot water in order to
melt the flossugar. When the bulk of the flossugar is removed, carefully
separate the heater coil from the sidewall to clean the areas where they
contact one another.
DO NOT IMMERSE HEATING ELEMENT TERMINAL LEADS IN WATER AS
THIS MAY CAUSE FAILURE!
6. The sidewall and heating element must be dry before reinstalling.
ABRASIVE OR MECHANICAL CLEANING OF HEATING ELEMENT AND
SIDEWALL IS PROHIBITED!
Re-assembly of the spinning head is done in the reverse order. Once
completed, turn on the motor and power to the heating coil for
approximately 30 seconds in order to spin off any remaining moisture.
Brush unit maintenance
As with most electrical motors, the Robo JetFloss utilizes brushes and slip
rings which are subject to wear and require inspection, maintenance and
eventual replacement.
To inspect and maintenance the brush unit it is necessary to take off the
stator (4) by removing the four fastening screws. Next remove the impeller
(7) by removing three fastening screws.
21
