ROBLIN VIZIO VERRE MURALE, Инструкция по установке

Страница: 10 / 60

8
plied with the chimney hood.
IN THE EXTRACTION MODE:
a. Place the anti-backflow flats
item 8
over the round outlet
item 6,
the telescopic duct and connect the
ducting 150mm (6 INS) over the round outlet on top of the canopy and secure the connections with
appropriate clamping rings or adhesive tape (
Fig. 6
).
b. Remove the grease filters (see paragraph Maintenance)
Fig. 5
being sure that the connector of the
mains cable is correctly inserted in the socket placed on the sides of the fan. Before fitting the chimney
to the canopy make the electrical connection as described in the section titled ELECTRICAL. When
the electrical connection has been made, test the lights and the fan motor.
c. Each chimney stack consists of two sections. Fit the upper sections (
Fig. 1 - item 7a & b
) first by
expanding the chimneys slightly to allow them to clamp around the bracket item 2 and secure the
chimney stacks to the brackets using the two M4 screws
item 12c
provided. Fit the lower chimney
sections by expanding the chimneys slightly to allow them from the top of the canopy to clamp around
the upper chimney sections.
d. Fit the 3 deflectors Item 9.
IN THE RECIRCULATION MODE:
a. Fit the recirculation spigot
R
onto the upper chimney wall bracket using the same fixing screws (
Fig.
2 item 2
).
b. Connect the ducting 150mm (6 INS) not provided between motors
item 6
and the recirculation spigot
and secure the connections with appropriate clamping rings or adhesive tape.
c. Remove the grease filters (see paragraph Maintenance)
Fig. 5
being sure that the connector of the
feeding cable is correctly inserted in the socket placed on the side of the fan. Before fitting the chimney
to the canopy make the electrical connection as described in the section titled ELECTRICAL. When
the electrical connection has been made, test the lights and the fan motor.
d. Insert the charcoal filter into the base of the motor housing and secure the filter with two metal secur
-
ing straps item A as illustrated in
Fig. 4 .
e. Each chimney stack consists of two sections. Fit the upper sections (
Fig. 1 - item 7a & b
) first by
expand-ing the chimneys slightly to allow them to clamp around the bracket item 2 and secure the
chimney stacks to the brackets using the two M4 screws
item 12c
provided. Fit the lower chimney
sections by expanding the chimneys slightly to allow them from the top of the canopy to clamp around
the upper chimney sections.
f. Fit the 3 deflectors Item 9.
IN THE REMOTE MOTOR MODE AND WITHOUT CHIMNEY:
Note:
The
Fig. 7 & 8
correspond to the versions without Motor and without chimney (SMC or WMC).
For this version it is necessary to install on the remote motor as indicated
pages 54 to 57
, a kit Filter
Item 10 provided with the hood.
GB