21
2.16 TH_HOLD
This function allows the Throttle Servo to be set to
a percentage of the total travel range. This is an
alternative to using the motors choke when starting up
the model. Throttle hold can be performed by pressing
the switch to stop the engine. It can be performed for
accident braking. When pressing the switch, throttle
trigger doesn't work until the switch is pressed again.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the TH HOLD function
and press ENTER.
3. Use the +/- Key to change the value.
4. Press EXIT to save and return to FUNCTION MENU,
press EXIT again to return to the Main Screen.
TERMS:
VALUE -- Throttle hold position.
Range: -120% to +120%.. Default value: 0%.
2.17 F/S
If the RF signal loss, it should occur the receiver adjust the Steering or Throttle or
both to a preset value. The servo value of Steering channel and Throttle channel in
the fail status can be set through fail safe function.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the F/S function and press ENTER.
3. Press ENTER to select a item.
4. Use the +/- Key to change the value.
5. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to
return to the Main Screen.
TERMS:
ST — To set the servo value of Steering channel. Range -120% to +120%.
Содержание R01502
Страница 8: ...8 2 2 Menu introduction ...
Страница 9: ...9 ...
Страница 27: ...27 4 Declaration of Conformity DOC ...