Robitronic
Pro-Master Manual
Operating Instructions
9
Error message
--Motor Check --
[Start]
return to sensor check
No RPM Signal
[Mode]
return to sensor check
On start of a motor check, no RPM sensor signal could be detected. Possibly the sensor cable was
not plugged in properly or the motor cable not connected properly. Test proper operation of the
RPM sensor (see section "Checking the RPM sensor" on page 7).
--Motor Check --
[Start]
return to sensor check
High Power
[Mode]
return to sensor check
If you use a big automotive battery and check a motor with 11 turns or less the power limit of the
Pro-Master will be reached. (Pro-Master message: „High Power“). In this case you must use a
battery with less capacity.
Don´t try a bigger one !!!!!
We recommend a Panasonic lead-acid battery Type LC-RC1217PG 12 Volt 17 Ah.
--Motor Check --
[Start]
return to sensor check
High Amp Signal
[Mode]
return to sensor check
Check the motor or the Shottky diode.
--Motor Check --
[Start]
return to sensor check
Battery Fault
[Mode]
return to sensor check
Check the voltage of the lead-acid battery.
