5. Initial Parameter set up (Users' set up)
It will be operated with the default value of the essential user settings when it is
connected to power for the first time. The screen displays the following information
in sequence and the user can change the value of parameter on each screen.
When you are willing to alter the parameter value in the program, press
Start/
Enter
key to make it blink then change the value with
INC
or
DEC
key. The
value will be stored by pressing
Start/Enter
key once.
It recognise the cell count of Lithium battery automatically at the beginning of
charge or discharge process to avoid from erroneous setting by user. But deeply
discharged battery can be perceived incorrectly. To prevent the error, you can set
the time term to verify the cell count by the processor. Normally, 10 minutes are
enough to perceive the cell count correctly. For the battery of larger capacity, you
may extend the time term. But if you set the time term too long for the battery of
smaller capacity, the charge or discharge process can be finished with in the time
term with the erroneous cell count. This may cause the fatal result. If the proces-
sor recognises the cell count incorrectly at the beginning of charge or discharge
process, you may extend the time. Otherwise, you had better use with the default
This shows the trigger voltage for automatic charge
termination of NiMH and NiCd battery. The effective
value ranges from 5 to 20mV per cell .if the trigger
voltage is set higher, there is a danger of over
charging the battery; if it is set lower, there is a
possibility of premature termination. Please refer the
technical specification of the battery.
(NiCd default: 12mV, NiMH default: 7mV)
-7-
LiPo / Lilo / LiFe
CHK Time 10min
NiMH Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
