5
Installation
5.
Drill the holes for the two chimney brackets and the two safety holes. Place wall plugs in each hole. Fix the upper
chimney bracket to the wall using two ST4x40mm screws. Place the appliance back on the fixing bracket and
fasten in place using two ST4x30mm safety screws.
6.
Only if ducting
‐ Mark and cut out the hole in the ceiling / wall to fit the ducting (160mm diameter max).
Warning: Chimney depth is 260mm. Ensure no part of the hole is greater than 255mm from the wall.
7.
Connect and secure the ducting (use duct tape if required).
8.
Place the chimney assembly back onto the appliance (take care the power cord is accessible & not trapped by
the chimney). Fix the lower chimney to the wall using two ST4x40mm screws.
9.
Extend the upper chimney to the ceiling and secure in place with two ST4x8mm screws (take care to tighten all
screws when lined up).
10.
Replace the filters. Remove any protective plastic (including from the filters). Connect to the power source.
Recirculation mode
1.
This unit can be installed to operate in recirculation mode where ducting is not a chosen/desired or practical
option. There are recirculation grilles fitted on each side of the upper chimney which allow the cleansed air to
return to the kitchen. Ensure that the side outlet grilles are not obstructed. Even a partial obstruction will restrict
the efficiency of the rangehood.
2.
Replace aluminium filters with charcoal filters.
