7
DC
Con
fi
guration
Plugging in and language selection
1. Place your radio on a
fl
at surface and plug the cable from the mains adaptor
into the
DC input socket
located at the rear of your radio (marked 'DC 9V')
ensuring that the plug is pushed fully into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into
the RJ-45 socket at the back of the radio.
3. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT:
The mains adaptor is used as the means of connecting the
radio to the mains supply. The mains socket used for the radio must remain
accessible during normal use. In order to disconnect the radio from the
mains, the mains adaptor should be removed from the mains socket outlet
completely.
4. When you apply power, the display on the radio will light up and say:
'ROBERTS'
and
'Stream 217'
. After a few seconds the radio will then enter
Standby and the clock will display '00:00' as shown.
To continue to setup your radio press and release the
On/Standby
button.
If this is the
fi
rst time that you use your radio (or after a Factory Reset) the
display will show
'Setup wizard'
and
'YES'
will be highlighted on the screen.
5. By default your radio will display all menus and messages in English.
If English is your preferred language then press the
Tuning/Select
control
to select
'YES'
and to begin setting up your radio.
If you selected
'YES'
please skip to step 1 on page 9.
6. If your preferred language is not English, then rotate the
Tuning/Select
control so that the 'NO' option is highlighted. Press the
Tuning/Select
control
to enter the selection.
Continue on the next page.
Setup wizard
Start now?
Setup wizard
Start now?
4
5,6
Содержание Stream217
Страница 102: ...99 Notes ...
