Con
fi
guration
10
Con
fi
guration
Plugging in and language selection
1. Place your radio on a
fl
at surface and plug the cable from the mains
adaptor into the
DC input socket
located at the rear of your radio
(marked 'DC') ensuring that the plug is pushed fully into the socket.
2. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT:
The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio
must remain accessible during normal use. In order to disconnect the
radio from the mains, the mains adaptor should be removed from the
mains socket outlet completely.
3. When you apply power, the display on the radio will light up and say:
'ROBERTS'
and
'STARTING'
with a progress indicator. After a few
seconds the radio will then enter Standby and the clock will display
'00:00' as shown.
To continue to set up your radio press and release the
On/Off
control.
If this is the
fi
rst time that you use your radio (or a Factory Reset has
been carried out) the display will show
'Setup wizard'
and
'YES'
will
be highlighted on the screen.
4. By default your radio will display all menus and messages in English.
If English is your preferred language then press the
Tuning/Select
control to select
'YES'
and to begin setting up your radio.
If you selected
'YES'
, please skip to step 1 on page 12.
5. If your preferred language is
not
English, then rotate the
Tuning/Select
control so that the
'NO'
option is highlighted.
Press the
Tuning/Select
control to enter the selection.
Continue on the next page.
4,5
3
