If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Automatic Plug and play setup
When your radio is first connected to a power supply (batteries or mains)
or after a power failure (when backup batteries are not installed), the Auto
setup
will proceed as follows:-
• Automatically search the FM band and store stations in presets.
• Automatically set the time and day of week.
• Automatically search and store stations in presets when MW or
LW are first used.
1.
Install batteries or connect to mains (see page 6). Your radio will show
"SEARCHING FM PLEASE WAIT' followed by a Demonstration of the
RDS features available.
2.
The auto time indicator
will flash in the display whilst time setting
is carried out.
3.
If the first station detected by the automatic setup does not carry
C
lock
T
ime information your radio will automatically change to another
station after 1-2 minutes. This process will repeat until the clock is set.
4.
Your radio is ready for use when the
Auto Time indicator
stops
flashing.
5.
Press the
Power button
to switch on your radio and press one of the
Preset buttons
to select a station. Adjust the volume using the
Volume control
. To switch off your radio press the
Power button
.
Note:-
Auto setup (
AMT
) can take up to 5 minutes to complete and is
dependent on the signal strength and number of stations in your area.
To interrupt the Auto setup (
AMT
) press and release the
Memo button
.
Should Auto setup fail, setting the clock and pre-setting stations can
be carried out manually as described in the following sections.
D is p la y
7
9
8
1
2
3
4
5
6
1 0
ON
2
R9906 Instruction Book.pm6
24/10/99, 14:22
3
