13
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press
the
On / Standby button
to switch on your clock radio.
3. Press
the
Function button
to select the FM band.
4. Press
the
Tuning Up
or
Down button
to tune to a station. The
frequency will change in steps of 50kHz.
If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set
the
Volume
to the desired setting.
7. To switch off your clock radio press the
On / Standby button
.
Note: (Headphones only)
If you fi nd that FM reception is poor, try repositioning the wire aerial, up
or down or side to side.
If you fi nd that an FM broadcast has a lot of background hiss, this may
often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section "Stereo / Mono setting - FM"
on page 27 for further details.
2
3
4
4
Содержание DreamTime
Страница 4: ...3 Controls rear 15 Loudspeaker 16 Headphone socket 17 DAB FM wire aerial 15 17 16...
Страница 34: ...33 Notes...
