If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
12
Operating your radio - FM auto-tune
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
vertically either above or below the radio.
2. Press
the
On / Standby button
to switch on your clock radio.
3. Press
the
Function button
to select the FM band.
4. Press and hold down the
Tuning Up button
for 2 - 3 seconds to cause
your radio to search from low frequency to high frequency and to stop
automatically when it fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. To fi nd other stations press and hold the
Tuning Up button
as
before.
7. Press and hold down the
Tuning Down button
for 2 - 3 seconds to
cause your radio to search from high frequency to low frequency and
to stop automatically when it fi nds a station of suffi cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust
the
Volume
to the required setting.
10. To switch off your clock radio press the
On / Standby button
.
Note: (Headphones only)
If you fi nd that FM reception is poor, try repositioning the wire aerial, up
or down or side to side.
If you fi nd that an FM broadcast has a lot of background hiss, this may
often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section "Stereo / Mono setting - FM"
on page 27 for further details.
2
3
4,6
7
Содержание DreamTime
Страница 4: ...3 Controls rear 15 Loudspeaker 16 Headphone socket 17 DAB FM wire aerial 15 17 16...
Страница 34: ...33 Notes...
