6
Using the clock radio for the
fi
rst time
1. Place your clock radio on a
fl
at surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio. Plug the adaptor into a standard 13 amp mains socket
outlet.
IMPORTANT:
The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the mains adaptor should
be removed from the mains socket outlet completely.
4. When your clock radio is
fi
rst switched on the clock display will show
'Welcome to Digital Radio'
for a few seconds and the display will show
'00:00' and the unit will enter the Standby mode. It will then scan for
DAB radio stations and when stations have been found the clock and
date should be set automatically.
5. If no stations have been found then the clock will not set. You may need
to relocate your clock radio to a position giving better reception. You
should then carry out an auto-tune to
fi
nd stations. See Finding new
stations on page 12. The clock will then be set from a DAB broadcast.
Upgrade
DC In
12V /2.5A
