SECTION 1: H
EATER
S
AFETY
1 of 21
SECTION 1: HEATER SAFETY
Your Safety is Important to Us!
This symbol is used throughout
the manual to notify you of
possible fire, electrical or burn
hazards. Please pay special
attention when reading and
following the warnings in these
sections.
Installation, service and annual inspection of heater
must be done by a contractor qualified in the
installation and service of gas-fired heating
equipment.
Read this manual carefully before installation,
operation or service of this equipment.
Due to the nature of gas conversions, it is important
you use the correct conversion kit for the heater
model and gas you are converting to. Use only
genuine ROBERTS GORDON
®
conversion kits.
This heater is designed for heating nonresidential,
indoor spaces, where exposed surfaces of heating
equipment cannot exceed temperatures of 750 °F
(399 °C) in facilities where compressed natural gas
(CNG) or liquid natural gas (LNG) are present. Do
not install in residential spaces.
These instructions, the layout drawing, local codes
and ordinances, and applicable standards that apply
to gas piping, electrical wiring, venting, etc. must be
thoroughly understood before proceeding with the
installation.
Protective gear is to be worn during installation,
operation and service in accordance to the
Occupational Safety and Hazard Administration
(OSHA). Gear must be in accordance to NFPA 70E,
latest revision when working with electrical
components. Thin sheet metal parts have sharp
edges. To prevent injury, the use of work gloves is
recommended. The use of gloves will also prevent
the transfer of body oils from the hands to the surface
of the reflector.
Before installation, check that the local distribution
conditions, nature of gas and pressure, and adjust
-
ment of the appliance are compatible.
This heater must be applied and operated under the
general concepts of reasonable use and installed
using best building practices.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do no play with the
appliance.
For additional copies of the Installation, Operation
and Service Manual, please contact Roberts-Gordon
LLC.
1.1 Manpower Requirements
To prevent personal injury and damage to the heater,
two persons will be required for installation.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by
the product user when they are no longer legible.
Please contact Roberts-Gordon or your ROBERTS
GORDON
®
independent distributor to obtain
replacement signs or labels.
1.3 California Proposition 65
In accordance with California Proposition 65 require
-
ments, a warning label must be placed in a highly
visible location on the outside of the equipment (i.e.,
near equipment’s serial plate). Avoid placing label on
areas with extreme heat, cold, corrosive chemicals or
other elements. To order additional labels, please
contact Roberts-Gordon LLC or your ROBERTS
GORDON
®
independent distributor.
Содержание CORAYVAC CRVB04PN
