Robe Stage Faze 1500AT, Руководство пользователя

Страница: 6 / 9

6 7
6.2 Putting into operation
Warning: Never connect the StageFaze 1500 AT to a dimmer or switchpack! This may destroy the machine.
Connect the power plug to the mains supply. Make sure the correct voltage is selected.Switch on the power switch (10).
A P and two figures appear on the LED display e.g.:
After 60 Seconds, the StageFaze 1500 AT is heated up. Press the Enter-button once to start the Faze process. The green Active-LED will be lit. After
a short delay the machine begins to Faze.
After 30 Seconds the display will go dark. To re-activate it, press one of the buttons on the display.
6.2 Switching the StageFaze 1500 AT off
Press the Mode-button till „OFF” appears on the display and press the Enter-button.
On the display a small moving red line will appear.
Switch off the power switch (10)
When you switch off the DMX signal, the fan will be switched off automatically after 15 seconds.
Note:
Please make sure that the StageFaze 1500 AT
will not be switched off too early to allow the fan to run until the device has cooled down. This will
ensure that no fluid remains in the vaporizer to come out as droplets when the device is switched on next time.
6.3 Control Choices
Fig.1: Adjusting the pump output Fig.2: Adjusting the fan output Fig.3: Adjusting the DMX start address
Fig.4: Changing to the Profile-Mode Fig.5: Switching the device Off
You may control the StageFaze 1500 AT externally through the 3-pin or 5-pin XLR sockets .
Please note: You can‘t hold down the Mode-button for scrolling through the Menu. The Mode-button has to be pressed only momentarily. If the Mode-
-button is pressed more than two seconds, the machine will change into the Timer-Mode.
An outstanding feature is the adjustable output of the StageFaze 1500 AT. The pump and the fan can be easily and separately adjusted and regulated
in 99 steps via buttons.Any desired effect can be achieved in steps of 1%: from the finest mist to a thick Faze, similar to fog. To achieve the thickest
effect the pump must run at 99%, the fan at 1%. The finest Faze can be achieved with lower pump and higher fan settings. The data can be readjusted
whenever you want to.
Profile/Timer-LED,red
Active-LED,green
DMX-LED,yellow
LED display
Mode-button Up-button Down-button Enter-button