Robe ROBIN LEDBeam 350, Руководство пользователя

Страница: 20 / 39

20
Dimmer C - Dimmer curve . Use the menu to select desired dimmer curve.
Linear - a linear curve.
Square - a square law curve.
LED Freq - LEDs frequency setup . The function allows you to set the PWM (Pulse Width Modulation) output
frequency of LEDs to Standard or High. You can select from the following values:
300 Hz
600 Hz
1200 Hz
2400 Hz
High
LED Fadj - LEDs frequency fine adjustment . The function allows you to change the selected PWM output
frequency of LEDs in 6 levels up and down around the selected frequency in the menu “LED Freq”.
-06...-01 - Frequence levels 1-6 under selected frequency.
00 - Selected frequency
01...06 - Frequence levels 1-6 above selected frequency.
Temp Uni - Temperature unit . Use the menu item to change temperature unit from °C to °F.
I Ef Pos - Init effect positions . Use the menu to set all effects to the desired positions at which they will stay
after switching the fixture on without DMX signal connected.
Defaults - the menu item allows to set all fixture parameters to the default (factory) values.
5.4 Manual Control (Manual)
Use the menu to control all fixture channels by means of control buttons.
5.5 Test program (Test Prg)
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using ROBIN LEDBeam 350.
Static - Static mode . This mode is suitable for projections on the wall, ceiling or ground without
any head movement.
Dynamic - Dynamic mode. This mode uses all ROBIN LEDBeam 350 functions
including pan/tilt movement and therefore is good for a complete introduction of the fixture.
5.6 Stand-alone (St Alone)
Music T - Music trigger . Select this function to enable the sound control of the running program via the built-in
microphone.
Auto Run - Presetting playback . This function allows you to select the program which will be played in the
stand-alone mode after switching the fixture on. Selected program will be played continuously in a loop.
Off - the option disables „Auto Run” function.
Test - The option will start built-in test program.
Prog 1 - the option will start user-created program 1
Prog 2 - the option will start user-created program 2
Prog 3 - the option will start user-created program 3
Pr Play - Playing program . Select this menu to run a user-created program in a loop.
Test Prg - the option runs built-in test program.
Prog 1 - the option runs user-created program 1
Prog 2 - the option runs user-created program 2
Prog 3 - the option runs user-created program 3
Select the program you wish and press [ENTER]. The selected program starts running. By Pressing [ENTER]
again, program pauses running.
Pr Edit - Editing program . Select this menu to edit or create the program. The ROBIN LEDBeam 350 has one
built-in program and one user-editable program up to 40 steps. Each program step has a step time - during