Robe ROBIN iParfect 150 FW RGBA, Руководство пользователя

Страница: 16 / 32

16
The following menu items are accessible in the Standard control mode only.
5.1 Addressing (DMXA)
Set DMXA - Use this menu item to set the DMX start address of the fixture, which is defined as the first channel
from which the iParfect 150 will respond to the controller.
If you set, for example, the address 31, the iParfect 150 will use channels 31 - 48 for control (if Mode 1 is
selected).
Please, be sure that you do not have any overlapping channels in order to control each iParfect 150 correctly
and independently from any other fixture on the DMX data link.
If there is no data received at the DMX input, the display will start to flash "0001” with actually stored DMX address.
DMX Pres
-
DMX preset
. Use the menu to select desired channel mode.
Mode 1
- 17 control channels (default)
Mode 2 - 11 control channels
Mode 3 - 5 control channels
5.2 Fixture information (Info)
POn Time - Power on time . Select this menu to read the number of fixture operation hours.
Total - The item shows the total number of the operation hours since
the iParfect 150 has been fabricated.
Reset - The item shows the number of the operation hours that the
iParfect 150 has been powered on since the counter was last reset.
In order to reset this counter to 0, press and hold both [NEXT] and [PREV] buttons and
the [Enter] button at the same time.
DMX In - DMX readout. The menu is used to read DMX values of each channel received by the fixture.
Hea. Temp - Temperature . The menu shows temperature of the LED module.
Current - A current temperature of the LED module.
Highest - A maximum temperature of the the LED module since the fixture has
been fabricated.
High Res - A maximum temperature of the the LED module since the counter
was last reset.
I n order to reset this counter, press and hold both [NEXT] and [PREV] buttons and the
[Enter] button at the same time.
Sw Ver
-
Software versions
. Select this item to read the software version of the fixture modules.
IC-1
- A display processor.
IC-2
- A LED control processor.
5.3 Personality (Pers)
DMX Pres - DMX preset . Use the menu to select desired channel mode.
Mode 1 - 17 control channels (default)
Mode 2 - 11 control channels
Mode 3 - 5 control channels
DMX Input - Use the menu to select mode of DMX signal receiving.
Wired - DMX signal is received by means of the standard DMX cable.
Wireless
- DMX signal is received by means of the inbuilt wireless module (wireles DMX version only).
Display - Display adjusting . This menu allows you to adjust the display behaviour.
Turn - This function rotates menu 180 degrees from current orientation.
Note: Pressing and holding the Escape button also rotates menu.
On/Off T - This function allows you to keep the display permanent on or turn it off two
minutes after last pressing any button on the control panel.
Contrast - Use this function to adjust contrast of the display (0-100%).
Backlight - Use this function to adjust backlight of the display (0-100%).