Robe Robin 1000 LEDBeam, Руководство пользователя

Страница: 33 / 40

33
existing non-RDM equipment. By using a special „Start Code,“ and by complying with the timing specifications
for DMX512, the RDM protocol allows a console or dedicated RDM controller to send commands to and receive
messages from specific moving lights.
RDM allows explicit commands to be sent to a device and responses to be received from it.
The list of commands for Robin 1000 LEDBeam is the following.
Parameter ID Discovery command SET command GET command
DISC_UNIQUE_BRANCH
*
DISC_MUTE *
DISC_UN_MUTE
*
DEVICE_INFO *
SUPPORTED_PARAMETERS
*
SOFTWARE_VERSION_LABEL *
DMX_START_ADDRESS * *
IDENTIFY_DEVICE
* *
DEVICE_MODEL_DESCRIPTION *
MANUFACTURER_LABEL
*
DEVICE_LABEL * *
SENSOR_DEFINITION
*
SENSOR_VALUE *
DISPLAY_INVERT * *
DISPLAY_LEVEL
* *
PAN_INVERT * *
TILT_INVERT
* *
DEVICE_RESET *
DMX_PERSONALITY
* *
DMX_PERSONALITY_DESCRIPTION *
STATUS_MESSAGES
*
STATUS_ID_DESCRIPTION *
DEVICE_HOURS *
PARAMETER_DESCRIPTION
*
ROBE_DMX_INPUT * *
ROBE_WIRELESS_UNLINK
*
8. Wireless DMX operation
The Robin 1000 LEDBeam is equipped with the Lumen Radio CRMX module and antenna for receiving DMX
signal. CRMX module operates on the 2.4 GHz band.
The item " Wireless " from the menu "DMX Input" allows you to activate receiving of wireless DMX (Personal -
ity--> DMX Input -->Wireless.). First two options from the "DMX Input" menu are stated in DMX chart as well
(channel Power/Special functions , range of 10-19 DMX). If DMX input option is changed by DMX command,
the change is permanently written into fixture´s memory.
DMX range of 10-19 switching fixture to the wired/wireless operation is active only during first 10 sec -
onds after switching the fixture on.
After switching the fixture on, the fixture checks both modes of receiving DMX in the following order:
1. For the first five seconds, the fixture receives DMX signal from the wired input. If the Power/Special functions
channel is set at some DMX input option, the fixture will receive DMX value according to this option. If DMX input
option is set to the wired input , this option is saved and checking procedure is finished. If DMX input option is
not set, the fixture continues next 5 seconds in scanning wireless DMX signal-see point 2.
2. For the next 5 seconds the fixture receives wireless DMX signal and again detects if the Power/Special
functions channel is set at some DMX input option, if not, the fixture will take option which is set in the fixture