Robe Robin 1000 LEDBeam, Руководство пользователя

Страница: 31 / 40

3
following prog. step
- leaves menu without saving values
There is a chart describing behaviour of items "Pan/Tilt Macro" and "P./T. Macro Speed".
DMX
0 - 9
0 - 3
3 - 63
64 - 95
96 - 7
8 - 59
60 - 9
9 - 3
4 - 55
Pan/Tilt Macro
Disabled pan/tilt macro
Reserved
Figure of circle (from small to large)
Figure of horizontal eight (from small to large)
Figure of vertical eight (from small to large)
Figure of rectangle (from small to large)
Figure of triangle (from small to large)
Figure of star (from small to large)
Figure of cross (from small to large)
0
- 7
8 - 9
30 - 55
Pan/Tilt Macro Speed
No macro generation
Macro generation from fast to slow-forwards
No macro generation
Macro generation from slow to fast-backwards
6.6 Tab "Service"
Adjust DMX Values
- The menu allows you to set all effects to desired positions before fine calibration of the
effects .
Calibrations - This menu enables fine calibration of fixture effects and download default calibration values.
Calibrate Effects - The menu allows the fine adjustment of effects.
Pan - a pan position fine adjustment
Tilt - a tilt position fine adjustment
Calibrate Colours - The menu serves for adjusting of LEDs saturation to achieve colour temperature
of 5600K for white output.
Red
- a red LEDs saturation fine adjustment
Green
- a green LEDs saturation fine adjusment
Blue
- a blue LEDs saturation fine adjustment
White
- a white LEDs saturation fine adjustment
By using these items you can calibrate and adjust effects to desired positions.
Calibration of the pan/tilt via the control board
1. Disconnect DMX controller from the fixture and enter the "Calibrate Effects" menu.
2. Use the [up arrow] and [down arrow] to find "Pan" and touch it to enter the fine effect adjustment screen.
3. Set desired value and save it by touching the [confirm].
4. Repeat steps 2 and 3 for next item.
5. After calibrating all effects, touch the [confirm] to save all adjusted values and reset the fixture.
Calibration of the colour saturations via the control board
1. Disconnect DMX controller from the fixture , open shutter and dimmer and set the Virtual col. wheel channel
to DMX=10 (white 5600K). Aim the light beam on the lux meter (e.g. Minolta CL-200 Chroma meter)
which is placed at min distance of 2.5m from the fixture
2. Set the menu item "Colour Calibration Mode" to On (Personality-> Colour Calibration Mode-> On).
3. Enter the menu "Calibrate Effects".
4. Use the [up arrow] and [down arrow] to find desired colour and touch it to enter the fine effect
adjustment screen.
5. By means of the Red, green, Blue and White items adjust the 51000K colour temperature as exactly as
possible (∆u´v´= 0).