ColorStrobe IP
11
IC2.b.
--- display processor 2
IC3.L.
--- LED processor 3
IC4.L.
--- LED processor 4
UiFi
--- Wireless DMX module (if installed)
tEMP
---
Fixture Temperatures.
Select this menu to read the temperatures of the fixture:
bASE.
--- temperature of the fixture inside
Cur.t.
--- the current temperature of the fixture inside.
Hi.tE.
--- the menu item shows the max. temperatures of the fixture inside since
the fixture has been fabricated.
rSEt
--- the menu item shows the maximum temperatures of the fixture inside since the counter
was last reset. In order to reset this counter to 0 you have to press and hold the UP and DOWN
buttons and at the same time press the ENTER button.
LEdS.
--- temperature of the LEDs PCB.
Cur.t.
--- the current temperature of the LEDs PCB.
Hi.tE.
--- the menu item shows the max. temperatures of the LEDs PCB since
the fixture has been fabricated.
rSEt
--- the menu item shows the maximum temperatures of the LEDs PCB since the counter
was last reset. In order to reset this counter to 0 you have to press and hold the UP and DOWN
buttons and at the same time press the ENTER button.
Temperatures can be displayed in either °C or °F - see the option “tnP.u.“ in the menu “Pers“.
DM.In.
---
DMX values
. Select this function to read DMX values of each channel received by the fixture.
4.3 Personality
Use this menu to modify the ColorStrobe IP operating behaviour.
DM.Pr.
---
DMX preset
. Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX
protocol" for detail description of each DMX mode.
dM.In.
---
DMX input
. Select this menu item to select desired DMX input:
UirE
--- Wired DMX.
UirL
--- Wireless DMX
UrLo
--- Wireless DMX –> wired DMX. The fixture receives wireless DMX signal and sends it to its
DMX output connector. Next fixtures can be connected to this fixture by DMX cable (fixture works
as a Wireless-DMX converter.
F.tin.
---
Max. Fade time.
Select this menu item to set a desired max. fade time (0-25.5 sec.). This adjusted fade
time influences fade of Red, Green, Blue,White and dimmer during DMX operation:
If time between two receiving DMX values is > than fade time set in the item “M Ftime“, the entire adjusted fade
time will be used.
If time between two receiving DMX values is < than fade time set in the item“M Ftime“, the adjusted fade time will
be reduced to fill entire time between the two receiving DMX values.
e.g “F.tin“=2sec. and fixture has received Red=0 DMX, after 5 seconds will receive from DMXcontroller Red=255
DMX. It means, that red will go to full intensity during 2 seconds.
“F.tin“=8 sec. and fixture has received Red=0 DMX, after 5 seconds will receive from DMX controller Red=255 DMX.
It means, that red will go to full intensity during 5 seconds. (Max, fade time is reduced from 8 sec. to 5 sec.).
