ColorStrobe IP
10
4. Control menu
The ColorStrobe IP is equipped with a 4-segment LED display which allows you to set the fixture´s behaviour
according to your needs, obtain information on its operation, control all range of effects and program it
in stand-alone mode.
The four control buttons have the following functions:
-
ESCAPE button-leaves menu without saving changes.
-
ENTER button- enters menu, confirms adjusted values and leaves menu.
-
UP and - DOWN buttons - move between menu items on the same level, sets values.
After switching the fixture on, display shows current DMX address
.
4.1 Fixture Address
Use this menu to set the DMX address of the fixture.
dM.Ad.
---
DMX addressing
. Select this submenu to set a DMX start address.
To set a DMX address.
1.
Press the ENTER button.
2.
Use the UP/DOWN buttons to select desired start address.
3.
Press the ENTER button to confirm the choice.
Note: After switching on, the ColorStrobe IP will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX input, the display will start to flash the set address.
DM.Pr.
---
DMX preset
. Select this menu item to set a desired DMX mode.
4.2 Fixture information
Use this menu to read useful information about the fixture status.
To display desired information.
1. Press the ENTER button.
2. Use the UP/DOWN buttons to select the required menu item.
3. Press the ENTER button to confirm the choice.
Po.ti.
---
Power On Time.
Use the menu item to read the number of operation hours of the fixture.
totL
- the function shows the total number of the operation hours since the ColorStrobe IP has been
fabricated.
rESEt
- the function shows the number of the operation hours since the counter was last reset.
In order to reset this counter to 0, you have to press and hold the UP and DOWN buttons and at the same
time press the ENTER button.
VErS.
---
Software Versions.
Select this function to read the software version of the fixture processors.
ICI.b.
--- display processor 1
