Robe ClubScan 150CT, Руководство пользователя

Страница: 7 / 21

6 7
4.2 Rigging the fixture
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down if
the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the first time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.
The projector should be installed outside areas where persons may walk by or be seated.
Important! Overhead rigging requires extensive experience, including calculating working load limits, installa-
tion material being used, and periodic safety inspection of all installation material and the projector. If you lack
these qualifications, do not attempt the installation yourself, but instead use a professional structural rigger.
Improper installation can result in bodily injury and.or damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The projector must never be fixed swinging freely in the room.
Caution:
Projectors may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do not install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector’s
weight.
Danger of fire !
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
1.Mounting via mounting holes
Remove the scan bracket by unscrewing the 2 bracket screws.
Mount the clamp (not included) to the one of the two mounting holes in the mounting base. This mounting holes
have a diameter of 12 mm. Fix the scan via the clamp on a truss and tighten the rigging clamp.
For overhead use always install a safety rope that can hold at least 10 times the weight of the fixture. You must
only use safety rope with screw-on carabine. Pull the safety rope through the mounting base and over the
trussing system etc. Insert the end in the carabine and tighten the fixation screw.
truss
safety rope
mounting holes
(diameter of 12 mm)
clamp