12
13
6. Controller mode
The fixtures are individually addressed on a data link and connected to the controller.The fixtures respond to
the DMX signal from the controller.
6.1 DMX addressing
The control panel on the front panel of the fixture allows you to assign the DMX fixture address, which is defined
as the first channel from which the ClubScan 150 will respond to the controller.
If you set, for example, the address to channel 7, the ClubScan 150 will use the channel 7 to 12 for control
.Please, be sure that you don’t have any overlapping channels in order to control each ClubScan 150 correctly
and independently from any other fixture on the DMX data link.
If two, three or more ClubScan 150 are addressed similarly, they will work similarly.
For address setting, please refer to the instructions under "Fixture address"(menu "
001"
).
Note:
After switching on, the ClubScan 150 will automatically detect whether DMX 512 data is received or not.If
there is no data received at the DMX-input, the display will start to flash
"001"
with actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the ClubScan
150 - the controller is switched off or defective, the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) to the last fixture in the link in order to
ensure proper transmission on the DMX data link.
Содержание ClubScan 150CT
Страница 1: ...Version 2 3 ...
