8
3. Wing joiner
Use Ropoxi 5-minute epoxy to glue the plywood
joiner in one wing panel. Allow the glue to set
hard, then glue the two wing panels together,
again using Ropoxi 5-minute epoxy. Check that
the wing roots line up exactly.
Allow the glued joints to cure completely.
4. Installing the tailplane
Use a sharp balsa knife to cut away the covering
film over the tailplane slot in the fin. Remove the
film over the joint area of the tailplane. The tail-
plane can now be glued in the fin using Ropoxi
5-minute epoxy. Glue the elevator hinges in the
tailplane using cyano.
Take care to set the tailplane exactly at right-
angles to the fuselage centreline.
3
4
Plywood wing joiner, 375 x 33 x 6 mm
Building and Operating Instructions - ZLIN 50LX Red Bull 1600mm ARF
No. FW004004
