ENGLISH
6
Instructions and User Manual
W I N G S
09
ARF
PNP
The battery will be fixed by a velcro loop on the front
battery tray. To avoid slipping the battery, a strip of Velcro
should also be glued to the wooden board under the
battery. For later adjustment of the center of gravity, this
can vary in its position. Only after the exact determination
of the center of gravity you make a mark on the battery
and the board.
11
ARF
PNP
Mount the propeller center section with propeller blades
on the motor shaft. Pay attention to a firm but sensitive
tightening of the nut. This is an aluminum thread! After
that you can fix the spinner cap. Improperly mounted
propellers can lead to a crash and cause personal injury
and damage to property! Take particular care during
installation!
12
ARF
First of all, install the servos in the servo slot. The servo
cables are pulled through the openings with a wire. The
green 6-pin MPX connector system should be used as the
connection to the fuselage.
10
ARF
PNP
The receiver has its place in the rear of the wooden tray
and should be fixed by velcro. You can already plug in all
servo plugs according to their assignment.
13
ARF
Then make the aileron linkage from the M2,5 threaded
parts and clevises (the shorter of the two rods). Hook the
aileron linkage into the rudder and servo horns (outer
servo). Pay attention again to the neutral position of the
rudder with a right-angled servo horn and adjust this
if necessary at the clevises. Fix the threads with screw
locking lacquer.
Then make the aileron linkage from the M2,5 threaded
parts and clevises (the shorter of the two rods). Hook the
aileron linkage into the rudder and servo horns (outer
servo). Pay attention again to the neutral position of the
rudder with a right-angled servo horn and adjust this
if necessary at the clevises. Fix the threads with screw
locking lacquer.
