Safety Notes regarding LiPo batteries:
• Do not place the battery in water or any other liquid.
• Do not heat or incinerate the battery; do not place it
in a microwave oven.
• Avoid short-circuits, and never charge the battery with
reversed polarity
• Do not subject the battery to pressure or shock loads, and
never distort or throw the pack.
• Never solder directly to the battery
• Do not modify or open the battery
• Batteries must only be charged with a suitable charger;
never connect the battery directly to a mains power supply.
• Never charge or discharge a battery in bright
sunlight, or close to a heater or open fire.
• Do not use the battery in areas subject to
high levels of static discharge.
• Any of these errors can result in damage to the battery,
explosion or even fire.
• Keep the battery out of the reach of children
• Do not allow escaped electrolyte to come into contact
with fire, as it is highly inflammable, and may ignite.
• Avoid the fluid electrolyte contacting the eyes.
If this should happen, flush with copious amounts of clean
water and contact a doctor without delay.
• The fluid electrolyte can also be removed from clothing
and other objects by rinsing in plenty of water.
12
Safety Notes
The battery must not be left unsupervised during the charge process
or be placed on an inflammable surface. Protect from damp. Do not
subject it to direct sunshine, and do not cover the charger.
Do not charge batteries that are hot to the touch. Allow batteries to
cool down to ambient temperature. Charge the battery only using the
charger included in the set; do not use any other charger. The char-
ger should only be used to charge the battery included in the set. Not
suitable for charging the transmitter battery!
LIABILITY EXCLUSION
Since robbe Modellsport is not in a position to monitor the
handling of these batteries, we expressly deny all liability and
guarantee claims where the batteries have been incorrectly
charged, discharged or handled.
Operating Instructions,BLUE ARROW NANO LOOP 2.4 GHz No. S2531
Connect the charger using the sup-
plied USB charge lead.
Two batteries can be charged simul-
taneously. Connect the USB charge
lead to your PC and plug one or both
flight batteries in the charge sockets
on the side of the charger. During the
charge process a red monitor LED
glows. As soon as charging is finis-
hed, then the monitor LED goes out.
Charging the transmitter:
dry cells cannot be recharged - explosi-
on hazard! The transmitter can only be charged when the switch is
at the "Off" position. The charge current via the transmitter's charge
socket must not exceed 1 A.
Charging the flight battery
