6
Figure 6
Figure 5
continued from preceding page
read “Learning ICX #1 — Advance? OK
.”
If you are programming the monitor for a second towed
vehicle, press the button with the left-hand arrow (<) on
the monitor to scroll to the next message — “Learning ICX
#2 — Advance? OK
.” If you are programming the moni-
tor for a third or fourth towed vehicle, continue to press
the button with the left-hand arrow (<) on the motorhome
monitor to scroll to the appropriate message in this series
— “Learning ICX #3…” or “Learning ICX #4…”
5.
Press the “Test” button (Figure 6) on the Even Brake
touch pad control panel. Even Brake will begin a self-
diagnostic test.
(As part of the test, Even Brake will cycle the brake
pedal clamp up and down three times. When the brake
pedal clamp is depressed, the LCD display on the motor-
home monitor will read “Braking.”)
6.
After Even Brake has completed the self-diagnostic
test, the test light on the touch pad control panel (Figure
6) will illuminate green to indicate the system is ready, or
red to indicate the system is not ready.
•
If the test light is green and the LCD display reads
“Test Is Good — System Ready,” the motorhome monitor
is programmed to the ICX transmitter. When the vehicle is
towed, the monitor will display braking activity and system
status information from Even Brake.
The monitor can be programmed in this manner for up
to four vehicles. Once programmed, the monitor will au-
tomatically recognize the ICX transmitter in each vehicle
without further adjustment.
•
If the test light is red, check the motorhome monitor
LCD text display for detailed information. You can also
refer to the “Communications” sections (“Overview” and
“Reference Chart”) in the Even Brake owner’s manual.
7.
Before towing, read the owner’s manual, cover to cover.
Understand how to install and operate Even Brake, and
carefully follow the instructions and safety precautions.
Read all instructions before installing or operating
your Even Brake. Failure to understand how to install
or operate Even Brake could result in property dam-
age, personal injury or even death.
The installation is complete. The remaining page de-
scribes an alternative wiring method.
As a final step, test Even Brake to ensure that it has
been installed correctly.
After you are certain Even Brake is functioning as it
should, show the owner how to properly operate Even
Brake. Demonstrate how to connect and disconnect Even
Brake, and how to adjust the settings, until the owner is
comfortable with its operation.
Step F
Test all functions
1.
Follow the Even Brake owner’s manual to connect and
disconnect Even Brake, and to adjust its settings.
Note: the Even
Brake pedal clamp will
not fit the brake pedals
of a small number of
late-model Volkswagen
vehicles, such as the
2007 Volkswagen Golf. A photo of the 2007 Golf brake
pedal is shown to the right.
Use the optional 9329-VW replacement pedal clamp
for these vehicles.
