background image

IMPORTANT NOTICE!

Safety Definitions

  These instructions contain information that is very important to know and understand. This information is provided for 

safety

 and to 

prevent equipment problems

. To help recognize this information, observe the following symbols.

 

WARNING indicates a potentially hazardous situ-

ation which, if not avoided, could result in property 
damage, serious personal injury or even death.

  CAUTION indicates a potentially hazardous situa-
tion which, if not avoided, may result in property dam-
age, or minor or moderate personal injury.

CAUTION

  CAUTION used without the safety alert symbol in-
dicates a potentially hazardous situation which, if not 
avoided, may result in property damage.

NOTE

  Refers to important information and is placed in italic 
type. It is recommended that you take special notice of 
these items.

 

Read all instructions before installing 

or operating Even Brake. Failure to under-
stand how to install or operate Even Brake 
could result in property damage, personal 
injury or even death.

CAUTION

  Not for use on older vehicles without power brakes. 
Even Brake is designed to work with vehicles that 
have a power brake system (even though the power 
brakes are not activated while towing). Using Even 
Brake on vehicles that do not have power brakes will 
result in over-braking and severe non-warranty brake 
damage.

CAUTION

  Do not install Even Brake in a vehicle with an ‘ac-
tive’ braking system.
  ‘Active’ (or, ‘continuous power assist’) braking sys-
tems are a safety feature on some new vehicles. This 
feature allows the brakes to always have power, even 
with the ignition off. The only supplemental braking 
systems that ROADMASTER manufactures for these 
vehicles are InvisiBrake and BrakeMaster. A Brake 
Pressure Reducer (part number 900002) must also 
be used with BrakeMaster.
  If any ROADMASTER supplemental braking system 
other than these two is installed, the vehicle will brake 
with excessive force, which will damage the tires. 
Other non-warranty damage may also occur.
  It is the owner’s responsibility (or if professionally 
installed, the installer’s responsibility) to determine if 
the vehicle being equipped with supplemental brakes 
has an active braking system — refer to the vehicle 
owner’s manual or the dealership. ROADMASTER ex-
pressly  disallows any and all claims relating to tire

damage,  brake damage, or any other damage to ve-
hicles with ‘active’ braking systems caused by: 1) in-
stallation of any ROADMASTER supplemental braking 
system other than InvisiBrake or BrakeMaster; or 2) 
failure to install a Brake Pressure Reducer with the 
BrakeMaster.

 

The Even Brake 12-volt power cord is always

“last in, first out.” Never plug in the power cord until 
Even Brake is completely installed, according to these 
instructions. 
  Once it receives power, any movement of the box 
could cause Even Brake to activate unexpectedly. 
  Similarly, never disconnect Even Brake without first 
unplugging the 12-volt power cord. 
  Failure to install and operate Even Brake as in-
structed may cause property damage, personal injury 
or even death.

Statement of FCC compliance

  This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this 
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.

Содержание Even Brake 98400










Отзывы: