Roadmaster BASEPLATE KIT, Руководство по установке

Страница: 6 / 9

KIT# 524448-4
12/5/18
KS
Fig.R Fig.T
BASEPLATE KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 360-896-0407 fax 360-735-9300 www.roadmasterinc.com
15. Remove the fasteners attaching the wiring loom to the back of the fascia so the loom has enough slack to run it along
the top of the grille opening. On each side, drill one ¼" hole through the lip of the fascia in the upper corner of the grill
opening,
ensuring that the hole can't be seen from the front of the fascia
(Fig.S). Then, install the fasteners of the
loom into the drilled holes.
16. Cut out the enclosed template from the last page of these instructions and place it over the fascia (Fig.T). Drill a pilot
hole in the center of the circle, and then trim the fascia to match the template hole (Fig.T — inset). Trim clearance for the
safety cable tabs, as well as the plug mount, using the yellow lines in Figure U as a reference for trimming.
Fig.U
Fig.R Fig.S
drill ¼" hole
and remount
wiring loom
wiring loom
stock mount
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.