RND 305-00016, Руководство пользователя

Страница: 7 / 16

7
RND 305-00016 & 305-00017
ENGLISH
PROBLEM INDICATIONS POSSIBLE CAUSES SUGGESTED SOLUTION
Charger does not
work Indicator lights not
turn on No AC power
AC input socket fuse blown
Check AC connections are correct
Replace with correct AC fuse by qualified
electrician
No DC output Charger - On LED is
not on, Float and
Fault LEDs are on. Output short circuit
Over temperature protection triggered
Severe over loading charger
Reverse polarity connection
Check DC connections between charger
and battery
Check air intake vent at bottom of charger
is blocked or not. Check charger ambient
ventilation.
Check battery AH capacity within
recommended range
Check for correct polarity, replace car
blade fuse (7)
Battery does not get
full charge All indicator LED
work normally and
sequentially Bad battery connection
Battery type select switch in wrong setting
Battery capacity too large
Ambient temperature too low
Battery has damaged cell or battery is too
old
Check for loose contact, right cable size,
cable integrity
Recheck battery type and change to
correct battery selection
Make sure charger rating matches battery
capacity see table (B2)
Move battery to a room temperature
location, or get an optional temperature
sensor
Replace battery
Bulk LED is on all
the time Bulk light remains
on all the time when
Charger is in Power
Supply Mode,
LED(5) is on red. The connected load is too large, using
most of the current from the charger. Reduce the load to about 50% of the
charger's rating current Or take away the
load and set Charger to Battery Charger
Mode to fully charge the battery before
return back to the power supply setting
and load connection.
Bulk light remains
on all the time when
Charger is in Battery
Charger mode
LED(5) is on green. Wrong battery type selection
Battery is excessively depleted and the
soft charging is triggered
Battery temperature too high
Check charged battery label and change
battery type selection to correct setting.
Recharge the battery after a day, if bulk
light remains after several hours, the
battery is most likely damaged and cannot
accept charge. Replace battery.
Use optional accessory temperature sensor
I.
Trouble Shooting