Rhein-Nadel Automation GmbH
13
VT-BA-ESK2002_EN-2020 / 06.05.2020 SJ
5.2.
Starting-up the controller
To start up the controller, close the main disconnect switch. The main menu appears on the display showing the last
setpoint entered in channel 1 (feed rate of the bowl feeder).
KANAL l
KANAL 2
CODE
Alternatively, the following may appear on the display depending on the switching status of the device:
KANAL l
KANAL 2
CODE
External enabling signal has been activated but it is withdrawn from the device at the mo-
ment. (medium priority)
KANAL l
KANAL 2
CODE
Device has been switched off by operating the top left button of the membrane keypad, in-
hibiting all functions. (highest priority)
KANAL l
KANAL 2
CODE
The accumulation monitoring sensor is operated, switching off channel 1 (the vibratory
feeder). (low priority)
5.3.
Main menu / Setpoint entry and display for channels 1, 2 and 3
Display of setpoint or feed rate of
channel 1 (bowl feeder)
Alternatively: STOP, OFF or ACCUMU-
LATION (see above)
No entry possible
Entry of the codes to change or exe-
cute the required settings.
Enter code.
Description of codes see
under 4.4
Setpoint entry for channel 1
(bowl feeder)
Entry in %;
return to display mode
for saving
Setpoint entry for channel 2
(Linear feeder or belt hopper
with AC motor)
(not available with belt feeder)
Entry in %; return to
display mode for sav-
ing
Setpoint entry for channel 3
(Linear feeder or belt hopper with AC
motor)
(not available with belt feeder)
Entry in %; return to
display mode for sav-
ing
Use the cursor buttons (UP/ DOWN) to scroll through these five basic screens of the main menu. In each individual
item of the main menu you can press ENTER to activate this item for setting or changing. Upon pressing of the EN-
TER button the decimal point starts blinking. Now you can make changes using the cursor buttons (UP/DOWN). Press
ENTER again to acknowledge the entries made. The decimal point is no longer blinking. Using the cursor buttons you
can continue scrolling in the menu. Same procedure analogously applies to the code menus described below.
All the following display screens show the default setting. If the actual display on the controller differs from what is
shown here, the default setting has been changed in individual codes to suit a specific application.
KANAL l
KANAL 2
CODE
KANAL l
KANAL 2
CODE
KANAL l
KANAL 2
CODE
KANAL l
KANAL 2
CODE
KANAL l
CODE
KANAL 2
