RME Audio Hammerfall Multiface II, Руководство пользователя

Страница: 68 / 81

68
User's Guide HDSP System Multiface II
© RME
Unfortunately, very often it is not possible within the record software to assign a different input
channel to an existing track 'on the fly'. The loopback mode solves this problem elegantly. The
routing scheme stays the same, with the input channel 10 sent to any output via TotalMix, to
the Compressor, from the Compressor back to any input. Now this input signal is routed directly
to output 10, and output 10 is then switched into loopback mode via Ctrl-mouse.
As explained in chapter 30.5, the hardware input of channel 10 now no longer feeds the record
software, but is still connected to TotalMix (and thus to the Compressor). The record software
receives the signal of submix channel 10 instead – the Compressor's return path.
31. TotalMix MIDI Remote Control
31.1 Overview
TotalMix can be remote controlled via MIDI. It is compatible to the widely spread Mackie Con-
trol protocol, so TotalMix can be controlled with all hardware controllers supporting this stan-
dard. Examples are the Mackie Control, Tascam US-2400 or Behringer BCF 2000.
Additionally, the stereo output faders (lowest row) which are set up as
Monitor Main outputs in
the Monitor panel can also be controlled by the standard Control Change Volume via MIDI
channel 1 . With this, the main volume of the Multiface is controlable from nearly any MIDI
equipped hardware device.
31.2 Setup
•
Open the Preferences dialog (menu Options or F3). Select the MIDI Input and MIDI Output
port where your controller is connected to.
•
When no feedback is needed (when using only standard MIDI commands instead of Mackie
Control protocol) select NONE as MIDI Output.
•
Check Enable MIDI Control in the Options menu.
31.3 Operation
The channels being under MIDI control are indicated by a colour change of the info field below
the faders, black turns to yellow.
The 8-fader block can be moved horizontally and vertically, in steps of one or eight channels.
Faders can be selected to gang them.
In Submix View mode, the current routing destination (output bus) can be selected via REC Ch.
1 – 8. This equals the selection of a different output channel in the lowest row by a mouse click
when in Submix View. In MIDI operation it is not necessary to jump to the lowest row to perform
this selection. This way even the routing can be easily changed via MIDI.
Full LC Display Support : This option in Preferences (F3) activates complete Mackie Control
LCD support with eight channel names and eight volume/pan values.
Attention: this feature causes heavy overload of the MIDI port when ganging more than 2
faders! In such a case, or when using the Behringer BCF2000, turn off this option.