RJG Lynx ID7-M-SEQ, Руководство по эксплуатации продукта

Страница: 14 / 26

Lynx™ Shielded Sequence Module ID7‑M‑SEQ | Product Manual 8 RJG, Inc.
INSTALLATION SPECIFICATIONS
The instructions that follow are a general guide; actual steps necessary to install this product will
vary based on injection molding machine manufacturer, model, and options.
REQUIREMENTS
At minimum , the following signals must be wired
to the module:
•
injection forward,
•
screw run, and
•
mold closed/clamped.
If the machine sequence signals are wired
and assigned correctly, the
eDART system’s
sequencer function easily calculates accurate
machine signals. If the signals do not exist, the
eDART can calculate some machine sequence
signals, but may require the user to input
settings.
If the signals are misnamed, or do not go on and
off as specified, the system‑generated machine
sequence signals will likely be incorrect, as
will the data calculated from them. Refer to
“Machine Sequence Signals” on page 2 and
“Wiring” on page 9 for more information on
sequence signals and acceptable substitutions (if
applicable).
MOUNTING
CAUTION Before beginning ID7‑M‑SEQ
installation, disconnect and lockout/tag‑out any
and all power to the molding machine. Failure to
comply will result in personal injury or death, and
damage or destruction of equipment.
Mount the ID7‑M‑SEQ module to a solid
surface—such as the molding machine frame—
using the supplied 1.38” (35 mm) DIN rail. A
clearance height of 6” (152,4 mm) from the face
of the module is recommended.
NOTE Modules and connecting cables must
be located away from any static sources, such as
feeder tubes and material hoppers.