03-TM-0046 Page 7 of 13
FIGURE 2. BATTERY END CAP REMOVAL
2.5.2. PROCEDURE. To replace the battery, remove battery end
cap from beacon as follows:
2.5.3. Remove the three brass 4-40 machine screws from the battey
end cap. Lift that battery end cap to access the battery.
2.5.4. Remove battery from beacon. Replace with battery a 9 Volt
Alkaline or Lithium Battery. Note: Battery orentation is based on the
battery contacts. If battery is installed the wrong way, then the battery
end cap will note seat on the beacon housing.
