Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
6
Operator's Manual
XL Ladder Stand
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they are
there for your safety.
Recommended for adult use only.
1. Attach the front platform (6) and the rear platform (7)
together using two 5/16 x 18 x 2-1/4" bolts (28) and two
5/16" nuts (32). SEE FIGURE 1
2. Attach the platform supports (4) to the top of the rear
platform (7) by using four 5/16-18 x 2-1/2" bolts (27) and
four 5/16" nuts (32). SEE FIGURE 2
3. Attach the brace flat bars (18) to the back of the rear
platform (7) and to the platform supports (4) using four
5/16-18 x 1-3/4" bolts (23) and four 5/16" nuts (32).
SEE FIGURE 2
4. Attach rears of both armrests (17) to rears of seat side rails
(9) and to the platform supports (4) using two 1/4-20 x
3-1/4" bolts (25) and two 1/4" nuts (31). SEE FIGURE 3
5. Attach fronts of both armrests (17) to fronts of seat side rails
(9) using two 1/4-20 x 2-1/4" bolts (24), two yellow washers
(36) and two 1/4" nuts (31). SEE FIGURE 3
6. Attach the tree blade (10) to the backs of the seat side rails
(9) using two 5/16-18 x 2-1/2" (27) and two 5/16" nuts (32).
SEE FIGURE 3
7
28
6
32
EXPANDED METAL REMOVED FOR CLARITY
4
7
23
27
32
18
27
4
17
24
25
31
9
32
10
36
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely until all
parts are assembled together! Finger tighten plus one turn of a
wrench only! This will temporarily hold the lock nut on the bolt while
helping alignment of all parts! After all parts are assembled together,
all nut & bolt combinations must be completely tightened.
FIGURE 1
FIGURE 2
FIGURE 3
