Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
6
Operator's Manual
DELUXE Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut
on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be
completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they
are there for your safety.
Recommended for adult use only.
FIGURE
1
FIGURE
2
2. Attach the front of one amrest (11) to the side rail (4) using
one 1/4-20 X 2-1/4 IN bolt (19), one yellow washer (30) and
one 1/4 IN nut (25). SEE FIGURE 2.
3. Attach the rear of armrest (11) and shooting rail “A” (12) to
seat platform (5) using one 1/4-20 X 3 IN bolt (18), yellow
washer (30), polymer washer (29) and 1/4 IN nut (25). Put
polymer washer between armrest and shooting rail "A" and
the yellow washer on the outside of shooting rail "A". SEE
FIGURE 2.
1. Attach the two seat side rails (4) to the seat platform (5)
using four 5/16 X 18 X 2-1/4 IN bolts (22) and four 5/16 IN
nuts (26). SEE FIGURE 1.
4
22
26
5
11
4
19
30
25
12
5
18
30
29
25
