Page 6
6. First start-up
Important: The following description applies to
software version 1.21
and higher for
the processing unit (DK 7320.100) needed to operate the ISDN unit.
§
First start-up
When several SMS terminals are operated on the one ISDN bus, each of these SMS
terminals (and therefore every ISDN unit as well) must be assigned its own call
number for sending and receiving SMSs.
Note
the following before transferring SMSs over the fixed network.
(This is necessary only when an SMS command is to be sent to the ISDN unit.
Receiving SMS “alarm” messages does not require registration
. )
Registering at a network provider requires that an SMS is sent once only to this
provider (for example for Deutsche Telekom: the text “ANMELD” is sent to the call
number “8888”). See the section
“ISDN command”
below.
The following data must be entered before the ISDN unit is connected to the
processing unit.
Mandatory data:
ISDN MSN:
The MSN (multiple subscriber number) is assigned by the network provider.
Also the country code and the local area code must be entered (separated by “/”).
Example: +49/2772/570126
ISDN Command
Before an SMS can be sent over the fixed network, the ISDN unit must be registered
at an SMS centre. (This is necessary only when an SMS command is to be sent to
the ISDN unit.
Receiving SMS “alarm” messages does not require registration
. )
The Deutsche Telekom SMS Centre requires an SMS containing the text “ANMELD”
to be sent to the number 8888.
Enter
“8888 ANMELD”
in the field “ISDN Command”. The ISDN unit then sends this
message to the SMS centre.
When the ISDN unit is not to receive SMS messages any longer or is to be operated
at another socket, the command “8888 ABMELD” sent to Deutsche Telekom cancels
the registration.
PIN GSM-Card:
This field is not needed to configure the ISDN
Unit.
Service Center GSM:
This field is not needed to configure the ISDN
Unit.
Note: Phone Number 1 - 4
Mobile phone numbers must not
entered with the country code.
