For assistance, call RITRON at 800-872-1872, or go to
www.ritron.com
7
Repeat Message with multiple transmissions
You can set a limit to the number of times the message
will be transmitted at the scheduled intervals.
Example: Suppose you have placed a Quick Assist
®
at
the delivery door of your building. Your recorded
message might then be “Visitor at Delivery Door”. You
may want this message to be transmitted every two
minutes for approximately a quarter hour after the push
button has been pressed, and then to stop transmitting
until the button is pressed again. In this case, you would
program the message Wait Time for every two minutes,
and set the Message Limit to “8”, as described here.
When the push button is pressed the message is
transmitted every 2 minutes until it has been sent 8
times over a span of 16 minutes.
The Quick Assist
®
is set at the factory to transmit the
recorded message twice with a 30 second Wait Time in
between transmissions.
Wait time between repeated transmissions
This sets the amount of time the Quick Assist
®
will wait
between repeated transmissions.
Q
UICK
A
SSIST
®
D
EFAULT
P
ROGRAMMING
..........................................................................................................
TX Frequency
RQA-151
24
151.625
MHz
RQA-151M
22
154.600
MHz
RQA-451
26
467.850
MHz
QC/DQC Code
44
No
Tone
DQC Invert
No
Compand
No
Reset Operation
Reset from Front Panel Button
Reset Button Hold Time
5
sec.
Input Operation
Normal
Latching Input Mode
Yes
Debounce/Holdoff Time
10
sec.
Number of Inputs
1
TX Alert Tone
Yes
Battery Saver
Yes
Low Battery Message
Yes
Power Fail Message
No
Message Delay on TX
1
sec.
Recorded Messages
RQA Message
“Assistance needed”
Reset Message
“Call answered”
Power Fail
“Power fail”
Low Battery
“Low battery”
Number of Times Recorded Message
is repeated on each Transmission
1
time
Number of Times the Transmission is sent
2 times
Wait Time between Transmissions
30 seconds
