For assistance, call RITRON at 800-872-1872, or go to
www.ritron.com
4
1
2
3
4
5
6
9
10
7
8
I
DENTIFICATION OF
Q
UICK
A
SSIST
®
C
ONTROLS AND
C
ONNECTIONS
....................................................................
1 Battery
Holder
The battery holder accommodates the six (6)
standard “AA” alkaline cells required to power the
Quick Assist
®
.
NOTE: Always install a fresh set of alkaline
batteries before programming the unit.
2
Front Panel LED
The red front panel LED is lit whenever the Quick
Assist
®
is transmitting a message.
3
SMB Antenna Connector
This connects the internal antenna to the radio
printed circuit board.
4
External Audio Input
Allows input to the Quick Assist
®
voice recorder
from an external audio source, such as the Line
Out audio from your computer.
5 Microphone
Microphone for recording voice messages.
6
USB Programming Connector
Connects the Quick Assist
®
to the USB port on your
computer for programming.
7 Record
Button
Press this button to initiate voice recording.
8 Internal
Antenna
The internal antenna radiates radio signals.
9
Front Panel Push Button
When the front panel push button is pressed the Quick
Assist
®
transmits your pre-recorded voice message. This
sealed push button provides a water-resistant enclosure.
10 Battery Connector
In-line connector between the printed circuit board and the
battery holder.
IMPORTANT: Do not remove any other fasteners or further
disassemble the Quick Assist
®
unit; doing so risks damage to
the unit and voiding the manufacturer’s warranty.
FIG-1: CONTROLS & CONNECTIONS
