RITE-HITE SpanGuard, Инструкция по установке/обслуживанию/эксплуатации

Страница: 8 / 16

MAINTENANCE
Curtain Replacement
Removal
1 At the basket post assembly (Figure 5) :
• Remove the crank (D) from the crank storage clip (A)
•
Place the crank on worm shaft (C) to disengage
worm from worm gear by back threading until free.
• Lock worm shaft (C) in place by pushing it toward
the unit, the locking key (B) will engage and hold it
in place
2 Rotate the entire basket assembly 90 degrees by
releasing the locking key (H). The locking key will
re‑engage and lock the basket in the horizontal
position (I). The bumper (J) stops against the post
(Figure 7).
3 At the latch post assembly remove the curtain tube
handle from the upper hasp and lower hasp (Figure 6)
4 Place curtain on floor and remove any twists or folds
that could impede returning the curtain to the storage
basket
5 At the basket post assembly, place crank (D) on
worm shaft (C) (Figure 5) , and roll the curtain into the
basket
6 With the curtain completely stored inside the basket,
rotate the basket assembly back to the vertical
position by releasing the locking key The locking
key will re‑engage and lock the basket in the vertical
position Return the crank to the storage clip
BUMPER STOPS
AGAINST POST
QUICK
RELEASE
PIN
(5) SCREWS FOR ROLLER ACCESS
BASKET ROTATION
A
7 To access curtain, remove the (5) 1/4‑20 self
threading screws (A) (Figure 9) from upward
facing basket and remove shroud
NOTE: Do not remove the rivets
B
8 Unwind curtain from roller tube. After the curtain
is completely unwound from roller tube, remove
the 2 fasteners (B) that attach the curtain to the
tube Detach touch and hold fastener and remove
remaining curtain end
Figure 9
Figure 10
SpanGuard
®
Mesh Safety Barrier
Installation/Service/Owner's Manual
Rite‑Hite
®
8 Publication: AMEN00136 2019-11-22