HL-800 HYDRAULIC DOCK LEVELER
22
Pub. No. 1167-R2 - April 2003
OPERATING INSTRUCTIONS
Read and obey these instructions to prevent
personal injury.
• DO NOT operate leveler with anyone standing on,
or in front of lip.
• DO NOT stand on moving leveler.
• DO NOT operate leveler until truck/trailer is parked
against the dock bumpers and the truck/ trailer
has been secured.
• NEVER attempt to lift the lip or hold the lip out by
hand. Serious personal injury could occur.
• NEVER attempt to open dock door with leveler.
Serious personal injury could occur.
• NEVER enter a truck/trailer until its brakes are set,
air has been dumped from the air ride suspension
(if applicable), and you have visually inspected
truck/trailer to ensure truck/trailer is securely held
in place by a vehicle restraint or wheel chocks per
OSHA regulations.
• ALWAYS store the leveler platform so that it is
supported by the lip supports and that it is level
with the surrounding dock floor.
• NEVER release the vehicle restraint or remove the
wheel chocks until loading/unloading is finished
and the truck driver has been given permission to
drive away from the dock.
W A R N I N G
!
NORMAL OPERATION WITHOUT
AUTOMATIC RETURN TO DOCK (ARTD)
1. Push and hold RAISE button until leveler is fully
raised and lip is fully extended. See Figures 20
and 21.
2.
When lip is fully extended, release RAISE button.
The leveler will automatically lower down onto the
truck/trailer bed. See Figure 22.
3. When the truck/trailer pulls out, the leveler will move
to its lowest position and the lip will drop to the
pendant position.
4. To store leveler, push and hold the RAISE button
until leveler is about 6” above dock and lip is fully
pendant, then release button. Leveler will lower
down to dock level with lip resting in the lip supports.
NORMAL OPERATION WITH OPTIONAL
AUTOMATIC RETURN TO DOCK (ARTD)
1. Push and hold RAISE button until leveler is fully
raised and lip is fully extended. See Figures 20
and 21.
Figure 20
I M P O R T A N T
• If any load is on the leveler platform, DO
NOT operate.
• When the load/unload operation is
complete, it is suggested to return the
lever to the stored position.
Содержание LEVEL-RITE HL-800 Series
