I.
Hose Connection -
Slip the end of the hose onto the barb fitting of the valve assembly. Clamps and fittings
are furnished to secure the connection. Slide hose insulation up toward valve as far as possible, and fasten with
nylon tie wrap. The insulation will cover part of the valve when properly positioned.
J.
Drain Plug –
The pre-assembled drain plugs should go on the lower holes on the side-wall of the unit.
Install
drain plugs from inside of trough
. Wetting the plug can aid in proper installation.
NOTE
:
To drain the unit,
you can push the plug from outside of the unit in to the center of the unit, instead of reaching into the
water to pull the plug out. After the fountain drains, then reach in to retrieve the plug and install it from
the inside
.
K.
Seal the Base
- After the unit is completely installed, apply a bead of caulking around the base of the fountain
to ensure no wind enters through the base of the unit.
NOTE: sealing the bottom of the unit from cold air
is an important aspect of the unit's thermal performance.
L.
Install Unit Top -
Set the elliptical closures inside the unit base.
Place the top of the fountain on the base and
position the elliptical closures to sit in the drink wells. (Final placement will require the closures to float in the
well.) Thrifty King fountains employ the water seal design. Fill the water seal groove with liquid to seal against
air infiltration before assembling. Do not use foam seal in this area. Bolt the unit top down to the base using the
bolts, washers, and nuts provided.
Tip: You may use vegetable oil to fill the water seal groove, or coat the inside of the groove with
baking pan coating spray before filling with water to make the cover easier to remove and reinstall
during freezing weather. For areas with high evaporation, using vegetable oil may be necessary.
M.
Float Adjustment
- Turn on water supply, check for and correct any leaks, and adjust float levels. For Thrifty
King fountains, the water level should be adjusted to leave a gap of 1/2” between the elliptical closure and the rim
of the water well. If the closure rests against the rim, they are more likely to freeze together.
N.
Install Valve Chamber Cover
- Again fill the water seal groove with liquid to seal against air infiltration
before assembling. Do not use foam seal in this area. For the CT6, use the J-bolts provided to attach the valve
chamber cover to the top. For all other units, drop in the valve chamber cover.
O.
Cleaning Your Fountain
– To clean your watering fountain you will need a good stiff bristled brush.
Remove the cover then brush the water seal groove to remove any build-up then brush the tank. Remove the
drain plug that is located at the end of the trough to drain out the water and debris. You can shut off the water with
the shut-off valve located under the unit or by holding the float in the up position. After the water and debris has
drained reinstall the plug and let the tank refill. Now is a good time to readjust the float if needed. Reinstall
cover and
you are
done.
Thrifty King Product Specifications
CT1-2000
CT2-2000
CT4-2000
CT6
Drink Height
19
19
19
19
Width
20.25
24
35
39
Length
28
42.75
42.75
72.5
Shipping Weight
53 lbs.
90 lbs.
152 lbs.
210 lbs.
Operating Capacity
11.2 gallon
28 gallon
45.5gallon
55 gallon
Herd Capacity
30 Head
100 Head
200 Head
300 Head
Thrifty King CT Series Instruction Manual
3
25 September, 2014
