7
Controls
Sensor Calibration
1.
Calibrate the sensors before the first flight.
Turn on
the transmitter. Center all the trim adjustments. To
center the trim settings, hold down one side of the
trim button until you hear a long beep. If the
controller stops beeping, release the trim button
and hold down the other side.
2.
Plug in the House Racer and place it on a level
surface.
3.
Hold the right stick in its lower right corner.
4.
Move the left stick
down
and to the right. When
the LEDs on the House Racer start to flash, release
both sticks. The LEDs will stop flashing when the calibration is complete.
Motor Arming
While the throttle is at its lowest setting, hold the
yaw control to the right to arm the motors. Holding
the yaw control to the left while the throttle is at
its lowest setting will disarm the motors. The motors
will also shut off if the throttle is at its lowest setting
for more than 3 seconds.
Arm
Arm
Disarm
