4
Wireless Sounder Instructions
Mounting the Sounder
1. Release the mounting bracket captive locking screw (Fig 1).
2. Turn the mounting bracket counterclockwise and separate it from the sounder.
3. Hold the mounting bracket against the wall (direction arrow pointing up) and mark the
locations of the mounting holes (Fig. 2).
Drill the desired mounting holes and insert
screw anchors (if required).
NOTE:
Do not drill through the mounting bracket.
4. Mount the bracket to the wall using the supplied screws.
5. Insert the supplied batteries into the battery chambers (speaker and radio) paying
attention to the polarity (Fig 3).
6. Perform communication set up with the control panel (see Sounder/Receiver
Communication Set up paragraph).
7. Once communication setup is completed, mount the sounder to the mounting bracket
by turning the sounder clockwise. Pay attention to the tamper switch.
8. Secure the captive locking screw.
Mounting
Bracket
Tamper
Protection
Screw
Fig. 1
Fig. 2
Speaker
Batteries
(6V, Serial
Connection)
Radio
Batteries
(3V, Parallel
Connection)
Tamper
Speaker
Fig. 3
