4
mean the Shutter is bottom down, if the report value is 0xFF that mean the Shutter is
at the top. But if report value is 0xFE means the position is unknown.
Binary Switch Get Command
：
[Command Class Binary Switch, Binary Switch Get]
Binary Switch Report Command
：
[Command Class Binary Switch, Binary Switch Report, Value = 0x00
(BOTTOM)]
[Command Class Binary Switch, Binary Switch Report, Value = 0xFE
(UNKNOWN)]
[Command Class Binary Switch, Binary Switch Report, Value = 0xFF(TOP)]
2-2 BINARY_SWITCH_SET
PAN08 can only accept Binary Switch Set Command which value is either (0x00)
Bottom or Top (0xFF), other value is not acceptable.
[Command Class Binary Switch, Binary Switch Set, Value = 0xFF(255)]
control the shutter to the top (0xFF). But if the shutter is on the way down, this
command will stop the shutter.
[Command Class Binary Switch, Binary Switch Set, Value = 0x00(0)]
control the shutter to the bottom(0x00). But if the shutter is on the way up, this
command will stop the shutter.
3. Multilevel Switch Command Class (Version 3)
：
：
：
：
3-1 MULTILEVEL SWITCH SET:
PAN08 can accept Multilevel Switch Set Command which value is either (0x00)
Bottom or Top (0x63 or 0xFF) or (0x01-0x62) the position between TOP and Bottom.
Other value (0x64-0xFE) is not acceptable
.
[Command Class Multilevel Switch, Multilevel Switch Set, Value = 0x63 or
0xFF(255)] control the shutter to the top (0xFF)
[Command Class Multilevel Switch, Multilevel Switch Set, Value = 0x00(0)]
control the shutter to the bottom(0x00)
[Command Class Multilevel Switch, Multilevel Switch Set, Value = 0x01-0x62]
control the shutter to the position between Bottom and Top.
3-2 MULTILEVEL SWITCH GET
:
When PAN08 receive Multilevel Switch Get Command, it will send Multilevel Switch
Report Command to report the position of the shutter. When the report value is 0x00,
that mean the shutter is at the Bottom, if the report value is 0x63 or 0xFF that mean
the shutter is at the top, any other value between 0x01~0x62 imply shutter at the
position between top and bottom.
Switch Multilevel Get Command
：
[Command Class Multilevel Switch, Multilevel Switch Get]
Multilevel Switch Report Command
：
[Command Class Multilevel Switch, Multilevel Switch Report,
Value = 0x00(BOTTOM)]
[Command Class Multilevel Switch, Multilevel Switch Report,
Value = 0x01~0x62(Between BOTTOM and TOP)]
