background image

2

TECHNICAL DATA

• Input Voltage:

12v Pb battery or 
10~15v power supply

• Charge Voltage:

1~25 cells ( 1.2 to 30v )

• Fast Charge Current:

0.1 to 5.0A-dependant on 
battery being charged

• Trickle Charge Current:

– Manual Mode only:

Capacity/20 pulsed

– Tx battery:

50mA

– Ni-MH battery:

0mA

– Pb battery:

100mA

• Discharge Current:

20W

• Display:

2 x 16 Two Line LCD

• Cooling Fan

• Overload Protection

• Short Circuit Protection/Electronic Shut Off

• Reverse Polarity Protection on both Input and Output

• Pb battery charge function

• Size: 145(W) x 92(L) x 40(H)mm

• Weight: 560g

INPUT BUTTONS

SET/STOP:

This is used to enter and exit program 
mode and to stop charging and 
discharging procedure.

CHARGE/UP:

– Starts charging procedure.
– Increases figure/amount.
– Moves the cursor to the right.

DISCHARGE/DOWN:

– Starts discharging procedure.
– Decrease figure/amount.
– Moves the cursor to the right.

There are three input buttons on the SuperNova 250s.

EXTREMELY IMPORTANT - READ BEFORE USING CHARGER - SAFETY PRECAUTIONS

• Place the charger on a firm level surface for charging.

DO NOT

cover charger.

• Take great care over battery polarity, and observe the battery
manufacturer's recommendations.

• NiCad/Nickel Metal Hydride cells become 

WARM 

to the 

touch when charged. If the pack feels 

HOT 

to the touch, 

disconnect it at once.

• Connect the input leads to the 12v supply first, then connect
the battery to be charged.

ALWAYS 

disconnect the NiCad/Ni-MH /Pb battery when 

NOT

charging, as they may discharge themselves if left connected.

DO NOT

allow the input crocodile clips to touch each 

other or the case of the charger when the NiCad/Ni-MH/Pb 

battery is connected as this may cause a short circuit.

• Avoid short circuits.

• If NiCad/Ni-MH packs are severely overcharged they may
become very 

HOT

. For this reason it is always best to place the

pack on an insulated heat resistant surface for charging.

• The charger must 

ONLY 

be used in completely dry 

conditions.

DO NOT

disassemble the charger.

NEVER 

leave the charger unattended whilst charging.

DO NOT

fast charge batteries immediately after use while

they are still warm, allow to cool to ambient temperature
before charging.

CONNECTION TO POWER SUPPLY

The SuperNova is designed to operate using either a 12 volt
Lead Acid (Pb) battery or a suitable 10-15volt power supply.

Connect the 

red wire

from the charger to the 

+ terminal

of 

the power source, the 

black wire

to the 

– terminal

When correctly connected, the initial display will appear as 
follows, changing after a couple of seconds to, see top right.

SuperNova 250S Inst.Update  17/11/03  10:46 am  Page 2

Отзывы: