Start / Stop Button (Button MENU)
The Start / stop button can be used to start charging when the battery and charger are
already connected. In the menu, the button is activated by selecting ‘enable’. Before
disconnecting the battery from the charger and after charging has been completed, press
the button again. If prefered this button can be deactivated by selecting ‘disable’ in the
menu, in this case the charging will begin immediately when the battery and charger are
connected.
Limiting charging current (Current limit MENU)
In circumstances where the electrical installation does not allow or cannot be used for
such a large consumption of energy from
the mains supply network
(example: fuse
limited),
the
charging current in this case can be reduced to 20% of nominal. Charging
current is reduced in steps of
10%. In the case of setting the charging current to 20% of
the power consumption of the mains network of more than 650W.
Choosing the size of the battery (Battery Size MENU)
The battery size accommodated by the AP-3000 is from 50Ah, there is no maximum
limitation. The
ability
to
accept
electrical energy depends on the size of the battery. In
absorption phases, this varies greatly. The charging profile in the phases of absorption,
equalizing and maintaining adjusts to the battery size. To make sure that battery charging
is optimal, you can select the size (capacity) of the battery in the "Batt Size MENU".
RIPCHARGE UK, 3 CUTTS CLOSE, BRINKWORTH, CHIPPENHAM, WILTSHIRE, ENGLAND, UK.
+44 (0) 1666 510626 e-mail:[email protected]
