4
Wired OTG- configuration code
Before use wired OTG communication, you must read the below
setting code according to your application.
HID
USB Serial
HID mode:
Plug & Play. No extra driver is needed.
SPP mode:
must install PL-2303 driver to smartphone f irst.
Smartphone will recognize scanner automatically under
USB Serial mode
** Data output must be under “O – operation mode”
How to charge
(through Micro USB port or Type- C port)
A. Configuration code for charging
According to your charging cable (micro USB cable or type-C
cable), please scan the below setting code first.
Type C
Micro USB
B. Attention:
1.
Please use the
ORIGINAL
USB cable & power adapter (of
smartphone) to charge device.
2.
According to different smartphones, you must use corresponding
USB cable & configuration code for charging.
3.
Cannot plug micro USB cable & Type C cable to cradle for
charging at the same time.
4.
If you don’t follow the above instruction, quick charging or OTG
function will lose their functions.
Keyboard Country
(Wired OTG mode only)
Scan the appropriate country code as below to program the
keyboard layout for your country or language. As a general
rule, the following characters are supported, but need special
care for countries other than the United States
:
@ | $ # { } [ ] = / ‘ \ < > ~
USA
(Original setting)
Italian
Norway
France
Germany
Vietnam
Sweden
Spain
Denmark
Portugal
Switzerland
Hungary
1.
Place the mobile device holder by having the side of
open
and
close
red switch
on the right side of the scanner as presented on
the above image.
2.
CAUTION
: Please do not pull or press on any of the 4 extensions
or legs of the holder, for it can unbalance and disrupt the normal
function of the holder’s 4 extensions.
Place the mobile device
holder
lightly on the top of the base, so the 4
elevated studs fit into the 4 holes of the holder.
Holder’s back with 4 holes to fit on
and lock up with the 4 studs the
scanner.
4 Elevated Studs to fit into the
4 holes of the Holder’s back.
Holder’s front side: Make sure the red switch is on the right
side (exactly as the above picture shows), when fitting the 4
holes of the holder to the 4 studs of the scanner
Micro USB
Charging port
Type C
Charging port
