Rinnai RHFE-201FA, Руководство владельца по эксплуатации и установке

Страница: 14 / 40

Installation Instructions
A qualified service technician should install the
appliance and inspect it before use.
If you move, check the gas type in your new
area. The local gas authority will be able to
advise on local regulations.
The installation must conform with local codes
or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA
54
, or the Natural Gas and Propane Installation
Code, CSA B149.1 .
A manufactured home (USA only) or mobile
home OEM installation must conform with the
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280
, or, when
such a standard is not applicable, the standard
for
Manufactured Home Installations, ANSI/
NCSBCS A225.1 , or the standard for Gas
Equipped Recreational Vehicles and Mobile
Housing, CSA Z240.4
.
The appliance, when installed, must be
electrically grounded in accordance with local
codes or, in the absence of local codes, with
the
National Electrical Code, ANSI/NFPA 70 , or
the Canadian Electrical Code, CSA C22.1.
Appliance input ratings are based on sea level
operation and need not be changed for
operation up to 2000 ft (609.9 m) elevation.
For operation at elevations above 2000 ft
(609.9)
The appliance must be isolated from the gas
supply piping system by closing its equipment
shutoff valve during any pressure testing of the
gas supply piping system at test pressures
equal to or less than 1/2 psi (3.5 kPa).
If the flooring is carpet, tile, or other
combustible material other than wood, then the
appliance must be installed on a metal or wood
panel extending the full width and depth of the
appliance.
This appliance discharges a large volume of
warm air next to the floor. Any particles in the
air such as cigarette smoke could cause
discoloration in carpet. The warm air flow
could discolor nylon carpets containing dyes or
vinyl surfaces. To prevent discoloration of the
floor covering a mat may be placed under the
appliance which extends about 30 inches (750
mm) in front of it.
This appliance is not designed to built in.
This appliance is only for use with the type of
gas indicated on the rating plate. This
appliance is not convertible for use with other
gases unless a certified kit is used. If a
conversion of the unit is needed, conversions
must be performed by a qualified service
provider at the owner’s expense.
This appliance must not be connected to a
chimney flue serving a separate solid-fuel
burning appliance.
Rinnai suggests that a dedicated electrical
circuit with a 120VAC, 60 hz, 10 amp power
source be used.
Two 1/8 in test plugs are provided for testing of
manifold differential pressure.They are located
General Instructions
WARNING
Do not use substitute materials.
Use only parts certified with the appliance.
The appliance should be correctly sized for the
space it required to heat.
Follow the installations instructions and those in
Care and Maintenance for adequate combustion
and ventilation air.
The flow of combustion and ventilation air shall
not be obstructed.
Clearances to access the appliance during
servicing are 2 inches (50 mm) from the sides,
40 inches (1 m) from the front, and 9 inches
(225 mm) from the top.
, refer to the Conversion Manual.
The appliance and its appliance main gas valve
must be disconnected from the gas supply
piping system during any pressure testing of
that system at test pressures in excess of 1/2
psi (3.5 kPa).
on the modulating gas valve and on the burner
manifold.
14
Rinnai Corporation RHFE-201FA