Rinnai RH-C1059-PBR, Инструкция по эксплуатации и монтажу

Страница: 11 / 24

9
Installing the Grease Filter

Insert back the grease filter and lock it in place, at the same time take hold of the grease
filter from underneath using your other hand to insert into the grease filter holder, make sure
the grease filter is positioned correctly.

If the grease filter has not been inserted correctly, open the lock and reinsert it again.
Cleaning the Appliance Body
 Clean the extractor hood using warm detergent solution and a soft damp cloth. After
cleaning, dry it using a lint free cloth.
 Avoid using corrosive or abrasive products that could damage the surface.
 Do not clean the controls with a wet cloth as this may risk damage due to ingress of humility
into the electronic circuitry
Cleaning the Perimeter LED Light Panel
(Fig.2 & Fig.2.1)
Fig. 2 Fig.2.1
For perimeter LED light panel which are heavily soiled.

Gently pull down the perimeter LED light panel and disconnect the power cable.

Using both hands lift the perimeter LED light panel 45 degrees upwards towards the left
back hook open gap, gently slide the perimeter LED light panel out from the right side.

Spray the perimeter LED strip panel with warm water before cleaning with a solution of warm
water and a little washing up liquid using a soft damp sponge or damp cloth. The perimeter
LED light panel is protected from liquid and tested to IP 4 standard.

Reverse the procedure when fitting back the perimeter light board panel.
If the perimeter LED light panel is not heavily soiled

Gently pull down the perimeter LED light panel and disconnect the power cable

Clean the perimeter LED light panel with warm soapy water using a soft damp sponge or
soft damp cloth. Wipe off with a dry lint free cloth.

Reverse the procedure when fitting back the perimeter lamp board panel.