Installation
13
FIXING THE SHOWER TO THE WALL
Important:
The shower must be mounted on a
flat surface which covers the full width and
length of the backplate. It is important that the
wall surface is flat otherwise difficulty may be
encountered when fitting the cover and
subsequent.
1.1
Decide on a suitable position to allow for
cover fit and removal.
Determine the direction that you require the
inlet water supply and electrical cable to enter
the unit from.
Determine the height at which you require the
unit to be installed.
1.2
Unscrew the cover retaining screws
sufficient to remove the cover.
Note!
The cover retaining screws are captive
and should remain in the case.
1.3
Remove the cover.
Mark the position of the unit on the wall. Mark
the positions of the fixing holes. Make sure
that sufficient electrical supply cable is
available for connection to the terminal block.
1.4
Drill the holes and insert the wall plugs
provided. Secure the heater unit to the wall
with the screws provided. Avoid drilling into
any supply cable/pipe.
Note!
Hook the backplate over the top screws
and fit the lower fixing screw into position. DO
NOT fully tighten the screws at this stage, as
the fixing holes are elongated to allow for out
of square adjustment after the plumbing
connections have been completed.
Mount to wall
Screw x 4
Remove the Cover
Mark the mounting holes
Outlet
Inlet
